* Controls - The door will come as standard with either a remote
control unit (2 transmitters), a keyswitch (3keys), or a wall mounted button
* Powder Coat Finish (002C)
Powder coat finish is available in a wide range of colours and is
applied to the complete door on both sides. Powder coat is a more durable
and hard wearing finish and is ideally suited to roller shutters.
* Hoods And Fascias
Galvanised coil casing, fascias and motor covers are all available
at additional costs.
* Lockable box to enclose external key operated switch
A pressed steel locking box can be provided at additional cost to
accept a security padlock (Padlock provided by others). The locking box
secures the external key operated switch, providing additional security.
* Battery Back up (002E)
A device used to provide an alternative source of power to allow a
limited number of operations of the door, should the main power supply from
the consumer unit fail.
Industrial/Security Steel roller
We offer a wide range of roller shutters all manufactured and installed by ourselves and come complete with a 12 month guarantee. All steel shutters come fully galvanised with the option to add powdercoating to any standard RAL colour.
Suitable for all Industrial units, Loading bays, Shop fronts, and doors and
windows on commercial premises.
75mm deep galvanised cold rolled sections are interlocked together to form
the door curtain. The laths are concave in shape and are held together by
end locks secured by steel rivets.
The lath comes as standard in solid pieces but there is the option to have
perforated sections. This is most common on shop fronts and highly
compliments a back lit display.
Bottom Rail Section
The bottom rail is a galvanised section available in either a 'T' or 'L'
shape depending on purpose. Both are 75mm deep.
Side Guides and supporting angles
Guide sections are manufactured from 3mm purpose rolled section, with
different depths dependant upon the width of the shutter, and are pre
drilled ready for fixing to the structure.
Roller Shutter Barrel
The mild steel tube encases the single phase tubular motor in the majority
of cases. These are excellent for low usage doors which are typically
opened/closed once or twice a day. The motor head is secured to the shutter
end plate, with the outer body rotating to raise and lower the door. On
larger doors or doors that have a higher duty cycle then an outboard direct
drive or chain drive motor is often used and these are available in single
or three phase options. All motors will come with a manual override in case
of power failure as standard.
Standard electrical operation is by Single phase (240 volt) motor, I.P.44
rated motor. The motor is complete with integral limit switches, to enable
the shutter to stop automatically at final point of travel positions, and
also incorporates a manual override facility for use in the event of a power
failure. Outboard motors do vary and requirements will be supplied before
Location and Electrical Supply Requirements
The client is to provide, to each door prior to installation, a 13 amp
single phase supply, terminated to a fused spur, to within 500mm from the
motor position at high level. Outboard motors do vary and requirements will
be supplied before installation. We can offer this service at an additional
All steel parts are galvanised before fabrication. A high zinc spray is
applied to areas where the galvanised areas are disturbed to maintain rust
resisting qualities. Door curtains are supplied galvanised unless otherwise
Choose from electrically or manually operated with a choice of controls.
Various laths are available including perforated, punched.
roller shutters middlesbrough